Configuring Dsp Templates - AudioCodes Mediant 2000 User Manual


To configure general media parameters:
1. Open the General Media Settings page (Configuration tab > VoIP menu > Media
submenu > General Media Settings).
2. Configure the parameters as required.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 350.
12.6

Configuring DSP Templates

The DSP Templates page allows you to load up to two DSP templates to the device. In
addition, you can define the percentage of DSP resources allocated per DSP template.

To select DSP templates:
1. Open the DSP Templates page (Configuration tab > VoIP menu > Media submenu >
DSP Templates).
2. In the 'Add Index' field, enter the index number to add a new row in the table.
3. In the 'DSP Template Number' field, enter the desired DSP template number.
4. In the 'DSP Resources Percentage' field, enter the desired resource percentage for
the specified template.
5. Click Apply to save your settings.
6. To save the changes to flash memory, see ''Saving Configuration'' on page 350.
Notes:
SIP User's Manual
Figure 12-6: DSP Templates Page
•
You must either use the 'DSP Templates page or the
DSPVersionTemplateNumber parameter to select the DSP template, not
both. The DSP Templates page must be used only when two concurrent
DSP templates are required; the DSPVersionTemplateNumber
parameter must be used only when a single template is used.
•
If no entries are defined, the device uses the default DSP template (i.e.,
Template 0).
•
For supported DSP templates, see ''DSP Templates'' on page 655.
•
For configuring the Web interface's tables, see ''Working with Tables'' on
page 36.
158
Mediant 2000
Document #: LTRT-68814