Comtech EF Data CDM-700 Installation And Operation Manual page 21

CDM-700 High Speed Satellite Modem
Preface
Additionally, the CDM-700 has been shown to comply with the following standards:
EN 61000-3-2
EN 61000-3-3
EN 61000-4-2
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-4-8
EN 61000-4-9
EN 61000-4-11
EN 61000-4-13
IMPORTANT
•
Connections to the transmit and receive IF ports ('N' type female connectors) should
be made using a good quality coaxial cable - for example, RG213/U.
•
All 'D' type connectors attached to the rear panel must have back-shells that provide
continuous metallic shielding. Cable with a continuous outer shield (either foil or
braid, or both) must be used, and the shield must be bonded to the back-shell.
•
The equipment must be operated with its cover on at all times. If it becomes
necessary to remove the cover, the user should ensure that the cover is correctly re-
fitted before normal operation commences.
Harmonic Currents Emission
Voltage Fluctuations and Flicker
ESD Immunity
EFT Burst Immunity
Surge Immunity
RF Conducted Immunity
Power Frequency Magnetic Field Immunity
Pulse Magnetic Field Immunity
Voltage Dips, Interruptions, and Variations Immunity
Immunity to Harmonics
To ensure that the Modem continues to comply with these standards,
observe the following instructions:
xix
Revision 5
MN/CDM700.IOM