Comtech EF Data CDM-700 Installation And Operation Manual page 174

CDM-700 High Speed Satellite Modem
Remote Control
Command Arguments
Parameter (Instruction for Command
Type Code and or Response
Qualifier)
Serial Number N/A 9 bytes
Temperature N/A 3 bytes
Reboot RBT= 1 byte
Firmware N/A 1 bytes
Revision
Details
E3/T3/STS1 ETS= 3 bytes
Mode Select
Description of Arguments
to Query
Query only.
Used to query the unit 9-digit serial number. Unit returns its S/N in
the form xxxxxxxxx.
Example: SNO=176500143
Query only.
Unit returns the value of the internal temperature, in the form of
sxxx (ºC).
Example: TMP=+026
Command only.
Reboot.
Where n is:
1=System reboot
Example: RBT=1
Command or Query.
Firmware Revision Details
i=Bulk Image (1 or 2)
a=Firmware Image
b=Firmware Revision
c=Firmware Date
Example: FRW?1 (Firmware revision details for bulk image 1)
Command or Query.
Sets the E3/T3/STS1 interface card mode.
s=Interface Slot (1 or 2)
p=Interface Port (1 or 2)
m=Mode
0=E3
1=T3
2=STS1
(Note: Command valid Only with CDI-10 Dual G.703 interface)
Example: ETS=111 (sets Interface 1, Port 1 to T3 mode)
Response to
Command
N/A
N/A
RBT=
RBT?
RBT*
RBT#
FRW=
FRW?
FRW*
FRW#
ETS=
ETS?
ETS#
ETS*
11–24
Revision 5
MN/CDM700.IOM
Query
(Instruction
Response to Query
Code and
Qualifier)
SNO? SNO=xxxxxxxxx
TMP? TMP=sxxx
N/A RBT=n
FRW?i FRW={CR}Boot:{CR}a,
b,c{CR}Bulki:{CR}a,b,c{
CR}a,b,c...
ETS?sp ETS=spm