Eaton Network Management Card User Manual page 84

------------------------------------------------------------------------
NETWORK MANAGEMENT CARD
Network settings
------------------------------------------------------------------------
: MAC address [00:20:85:FD:1C:07]
1 : BootP/DHCP (0=Disabled, 1=Enabled) [1]
2 : IP Address [xxx.xxx.xxx.xxx]
3 : Subnet Mask [xxx.xxx.xxx.xxx] (1)
4 : Gateway Address [xxx.xxx.xxx.xxx]
5 : Host Name [ups1]
6 : UPS Domain Name [ups.domain.com]
7 : IPv6 (0=No, 1=Yes) [0]
8 : IPv6 Auto-config (0=No, 1=Yes) [0]
9 : IPv6 add.1/prefix len. [ ]
10 : IPv6 gateway address [ ]
(4)
11 : IPv6 local address
(4)
12 : IPv6 address 2
13 : Firmware upgradable (0=No, 1=Yes) [1]
14 : Primary DNS Server (IPv4 or IPv6) [xxx.xxx.xxx.xxx]
15 : Secondary DNS Server [xxx.xxx.xxx.xxx]
16 : SMTP menu
17 : SNMP menu
0 : Exit
----------------------------------------------------------------------
(1) Read-only or read-write according to "BootP/DHCP" status
(2) Read-only or read-write according to "IPv6 enabled" status
(3) Read-only or read-write according to "IPv6 enabled" and "IPv6 auto-config" status
(4) Read-only
(5) The value is a concatenation of the IPv6 address 1 and of the prefix length.
Network Management Card
(3)
(1)
(1)
(2)
(3)(5)
(3)
– User Manual 34003991XT_EN/EF
Page
84/127