Choice 1: Restart / Reset; Choice 2: Network Configuration; Choice 1: Read Ipv4&Ipv6 Network Settings - Eaton Network Management Card User Manual

7.1 Choice 1: Restart / Reset

Use this function to restart the card from the boot
This is equivalent to a restart of the electrical power supply.
-----------------------------------------------------------------------------
Reset
-----------------------------------------------------------------------------
1 : Restart the card from the boot
0 : Exit
-----------------------------------------------------------------------------

7.2 Choice 2: Network Configuration

Use this function to access network settings.
-----------------------------------------------------------------------------
Network settings
-----------------------------------------------------------------------------
1 : Read Network settings
2 : Modify Network settings
3 : Set Ethernet speed
0 : Exit
-----------------------------------------------------------------------------
7.2.1 Choice 1: Read IPv4&IPv6 Network settings
Enables reading of the card's routine settings
Network configuration :
MAC address : 00:20:85:FD:1C:07
Mode : Static IP
IP address : xxx.xxx.xxx.xxx
Subnet mask : xxx.xxx.xxx.xxx
Gateway : xxx.xxx.xxx.xxx
Link Local IPv6 address : xxxx::xxxx:xxxx:xxxx:xxxx /xx
Global IPv6 address : xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx /xx
Global IPv6 address : xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx /xx
Network Management Card
– User Manual 34003991XT_EN/EF
Page
106/127