Glossary - Eaton Network Management Card User Manual

9 Glossary

Bootp:
Protocol based on UDP used to allocate an IP address corresponding to an Ethernet card during the startup
phase. Defined by the RCF 951
CLI Command line interface
This interface allows direct access to the individual configuration parameters.
Community name:
Access key to access SNMP agent information
DHCP Dynamic Host Configuration Protocol
This IETF protocol enables remote, automatic, self-configuration of the IP addresses of a workstation.
DNS Domain Name Service
The DNS protocol ensure correspondence between the name of a machine and its IP address
Gateway
Interconnection equipment between networks with different conventions, to enable communication between them
HTML HyperText Markup Language
Language used to describe hypertext pages on the web.
HTTPS
Secure version of HTTP, the communication protocol of the World Wide Web. It was invented by Netscape
Communications Corporation to provide authentication and encrypted communication and is used in electronic
commerce.
IPP Intelligent Power Protector
Protection software installed on a PC or server to protect it
IPP SHUTDOWN CENTER
Communication software installed on a PC connected to the UPS to supervise it and communicate with Intelligent
Power Protector to insure power protection on servers
MIB Management Informatique Base
Group of software commands to control and administrate a device through the network. Each type of device
(server, hub, PC, UPS, etc.) has its own MIB
Network Management Card Page
– User Manual 34003991XT_EN/EF 125/127