Trap Receivers - Eaton Network Management Card User Manual

AdminSecurityLevel = 1|2|3 (1=No Auth, 2=Auth NoPriv, 3=Auth Priv)
AdminPassword = "xx..xx"
NotificationUserName = "xx.xx"
FirmwareUpgrade = 0|1 (0=No, 1=Yes)
Examples #> setSNMP User = "readuser"
(1)
Comments : Writing enabled according to "snmpVersion" status
(2)
: Writing enabled according to "WriteCommunitySecurityLevel" status
(3)
: Writing enabled according to "UserSecurityLevel" status
(4)
: Writing enabled according to "AdminSecurityLevel" status
(5)
: Don't forget to set echo off
(6)
: The length has to be 8 characters at least.
6.4.3

Trap receivers

6.4.3.1 "getTrap"
Purpose To read a trap receiver setting
Syntax getTrap N [option1] [option2]...
N = 0|1|2
options :
HostName
Name
TrapCommunity
TrapSnmpVersion
TrapSelectedMibs
Examples #> getTrap HostName Name
Comments
6.4.3.2 "SetTrap"
Purpose To modify a trap receiver setting
Syntax setTrap N [option1] [option2]...
N = 0|1|2
options :
HostName = "xx..xx"
Name = "xx..xx"
TrapCommunity = "xx..xx"
TrapSnmpVersion = Disabled|V1|V3|V1V3
TrapSelectedMibs = 0|1|2|3|4|5|6|7
Examples #> setTrap 0 Name="My application"
(1)
Comments : bit0 = 1 : MIB Pulsar enabled
bit1 = 1 : Power MIB enabled
bit2 = 1 : MIB IETF enabled
Network Management Card
(1)(4)(5)(6)
(1)
– User Manual 34003991XT_EN/EF
(1)
Page
96/127