Chapter 4 Rack and Optional Product Installation
4.3 Standard Installation Rules Before Shipment (Only for Regions Other than EMEA&I)
Table 4.2
(1)
Rack front space
(Space between the fixed part of the ETERNUS DX Disk storage system on
the front side and the front of the rack)
(2)
Mount bracket length
(Size between each end of the front and rear rack pillars)
(3)
Rack space
(Space between the fixed part of the ETERNUS DX Disk storage system on
the front side and the rear of the rack)
(4)
Rack mount kit installation area
■
Placement conditions
When determining service areas, refer to the installation document of the rack to be used.
Install air conditioning in order to ensure that the interior temperature of the rack satisfies the temperature
conditions listed in
4.3
Standard Installation Rules Before Shipment
(Only for Regions Other than EMEA&I)
This section explains the rules for combining the following optional products and standard installation rules
that apply before shipment from the factory.
•
Host interfaces
•
Drive enclosures
•
Drives
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Site Planning-
Specifications for the unit installation area
Specification
"2.1 Installation Specifications" (page 27)
Copyright 2013 FUJITSU LIMITED
and
"2.5.1 Air Conditioning" (page
69
Condition
40mm or more
685mm to 775mm
830mm or more
482mm or more
(recommended)
36).
P3AM-4822-12ENZ0