Power Connection; Joining All Networks - Christie Roadster User Manual

Installation & Setup
2.7 Power
Connection
2-28
To isolate just RS-422 communications, select "RS-232 and Ethernet Joined". In
Figure 2.36, only projector #3 will respond to the RS-422 controller. To isolate just
Ethernet communications, select "RS-232 and RS-422 Joined"—only projector #1
will respond via Ethernet.
The North American rated line cord is provided with each projector. Ensure
that you are using a line cord that meets the appropriate rating standards.
Plug the projector's high-current line cord into the line input socket located in the
lower right corner of the rear panel of the projector, then plug the 3-pronged end of
the line cord into a grounded AC outlet. Ensure the socket outlet is installed near the
equipment and is easily accessible. Input voltage to all Roadster and Mirage models
must be capable of 200 –240 VAC. Use the proper power source and the high-
current rated line cord provided. Refer to Section 6, Specifications for all power
requirements.
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range.
Caution for Shutdowns: Once the projector is turned off (
cooling fans will continue to run for approximately five minutes to ensure that the
projector and lamp have sufficiently cooled, at which point the fans will
automatically shut off. To avoid thermal stress that can lead to premature lamp
failure, never unplug the line cord while the lamp cooling fans are running, and
never unplug to power down.
Figure 2.36. Joining All Networks
WARNING
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
), the lamp
020-100002-05 Rev. 1 (02-2010)