Using The Keypads; Led Status Display; Built-In Keypad At Projector Rear - Christie Roadster User Manual

Operation
3.3 Using the
Keypads
Built-in 
Table 3.1

LED Status Display

3-4
Alternative location for working with the projector.
BUILT-IN KEYPAD -
INFRARED SENSORS -
receive infrared signals from the IR keypad for remote control of projector functions.
For proper operation, ensure these sensors are not blocked.
Laser radiation is emitted from the laser diode in the remote. Do not look
directly into the beam of the remote.
Using one of the following keypads typically controls the projector:

Built-in Keypad at the rear of the projection head

Remote Keypad for tethered or tether-less control (includes cable for connecting
as a wired remote)
While each of the keypads provides complete control of the projector, they differ
slightly in their arrangement of keys and in which functions can be accessed directly
with a key press rather than requiring use of the menu system. You may find one
keypad more convenient than another for your specific installation and application.
NOTE: The remote keypad has a single IR protocol and can be converted to a wired
remote by connecting the cable provided with the projector to the RCA jack labeled
as on the input panel.
REMOTE
To control the projector when signals from a remote keypad cannot reach the
projector, use the projector's built-in keypad (Figure 3.2). Two nearby status
windows provide feedback indicating current status and activities of the projector,
(See Table 3.1 below). Because the built-in keypad has fewer keys than the remote
keypad, certain projector functions are accessible only through the menu system
rather than via a direct key. NOTE: The built-in keypad cannot be disabled.

LED STATUS DISPLAY:
- -
On
LC
LP
SH
# #
The infrared (IR) sensors on the front and rear of the projector
Figure 3.2. Built-in Keypad at Projector Rear
DESCRIPTION
AC power supplied, projector Off
Projector On
Lens calibration in progress
Lamp has reached defined "Lamp Limit" refer to 3.9 Working with
the Lamp
Closed shutter
System warning or error has occurred
Cooling down (Rotating Horizontal Bars)
Power to Off state or Powering up (segments spinning clockwise
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)