Pixel Track; Pixel Phase; H-Position; V-Position - Christie Roadster User Manual

Operation
3-26

Pixel Track

Steady flickering or several soft vertical stripes or bands across the entire image
indicates poor pixel tracking. Proper pixel tracking helps ensure that the image
quality is consistent across the screen, that the aspect ratio is maintained, and that the
pixel phase can be optimized (described below). Tracking determines the frequency
of the pixel-sampling clock, indicated by the number of incoming pixels per line, so
that all pixels generated by a particular source are sampled.
NOTE: By default, the projector samples at the correct frequency for most sources.
For best results, use a good test pattern such as a smooth gray consisting of a clear
pattern of black and white pixels, or a similar "half on, half off" graphic image, such
as the Windows 2000 shutdown screen. Adjust the slidebar until the vertical stripes
broaden to the point where one large stripe fills the image. If the image still exhibits
some shimmer or noise, adjust Pixel Phase (below).

Pixel Phase

NOTE: Adjust "Pixel Phase" after "Pixel Tracking".
Adjust pixel phase when the image (usually from an RGB source) still shows
shimmer or "noise" after pixel tracking is optimized. Pixel phase adjusts the phase of
the pixel sampling clock relative to the incoming signal.
For best results, use a good test pattern such as a smooth gray consisting of a clear
pattern of black and white pixels, or a similar "half on, half off" graphic image, such
as the Windows 2000 shutdown screen. Adjust the slidebar until the image stabilizes
and each pixel is clearly defined. You may notice that you can stabilize the image at
more than one point—i.e., you may find that the image appearance at "11" is
identical to the image appearance at "38", thus you can use either setting.
If some shimmer from a video or HDTV source persists, use the "Filter" control to
remove high-frequency noise from the signal.

H-Position

This option moves the image right or left within the area of available pixels.
NOTE: The value shown represents where the approximate center of the image lies
in relation to the total number of pixels available horizontally. This varies widely
according to the signal—watch the image while adjusting.

V-Position

This option moves the image up or down within the area of available pixels.
NOTE: The value shown represents where the approximate center of the image lies
in relation to the total number of pixels available vertically. This varies widely
according to the signal—watch the image while adjusting.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)