3D Sync Input; 3D Sync Output - Christie Roadster User Manual

Operation
3-40
Adjust Dark Interval to artificially increase the amount of dark
DARK INTERVAL —
time between displayed frames for stereographic 3D images. Higher settings provide
more time for shutters in 3D glasses to open/close, ensuring that each eye sees the
full display intended for it. Symptoms of cross talk and/or color artifacts can indicate
need for adjustment. The Dark Interval range of adjustment depends on the vertical
frequency of your source—the higher the frequency, the smaller the range.
NOTE: For more information, refer to separate Using 3D in Mirage manual
provided.
This option defines 1) whether or not the sync will be frame
3D SYNC OUTPUT —
doubled on the output, and 2) whether or not the 3D frames must be inverted, i.e.
swapped left-with-right. The correct setting ensures that the projector's 3D display of
left/right frames is synchronized with the rest of the 3D system components so that
the intended eye sees the left/right image data. Select the option corresponding to
your 3D source connections and timing, and use only if the Mirage 3D Stereo Sync
Cable is connected between the projector's GPIO port and a server. Only the last
projector in the chain that is connected to the emitter will choose one of the emitter
choices; all other projectors will choose 'To Next Input'. Choose OFF when you are
not using the Mirage 3D Stereo Sync Cable.
With your sync cable and, if desired, emitter connected as described in the Using 3D
in Mirage manual, select the option suited to your 3D configuration (see above). If
Frame Delay is two (or 0), do not invert; if frame delay is one or three, invert.
Generally, an "Unlocked" setting is synchronized with the incoming L/R signal
rather than the vertical sync output, and may be needed only with multi-projector
installations in which the vertical sync outputs vary.
NOTE: For more information, refer to separate Using 3D in Mirage manual
provided.
Define which of the Mirage 3D Stereo Sync Cable's input
3D SYNC INPUT —
connecters is routed from your server. Use only if the cable is present. Only the first
projector, possibly connected to external sync, will choose any of these selections.
Every other projector will be getting sync from the previous projector on Input A or
Input B.
1. Input A
2. Input A, inverted
3. Input B
4. Input B, inverted
5. None / internal
6. None / internal, inverted
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)