STEP 3
STEP 4
STEP 5
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
Rotate the lens
Rotate the lens counter-clockwise
until the tabs are free from the lens
retainer ring, see A in Figure 4.11.
NOTE: The connector slide assembly
allows the connector to move as the
lens is rotated.
Pull lens out
Lens connectors will disconnect when
you pull the lens straight out from the
projector, see B in Figure 4.11.
Insert new lens.
NOTE: Remove small rear cap! Keep front cap on.
Electrical connector: Line up male connector on the lens with the female
connector on the connector slide assembly.
Insert lens: Align the tabs on the lens plate lock with the slots in the lens
retainer ring. Push the lens in until the tabs touch the back of the retainer ring.
Figure 4.10. Depressing Lens Release
Figure 4.11. Rotating the Lens
Maintenance
4-15