Shutter And Iris; Eyebolts; Handle; Filter Panel - Christie Roadster User Manual

Operation
Lens Offset 
Shutter and Iris 
Eyebolts 
Handle 
Stacking Mounts &
Stacking Legs 
Adjustable Feet 
Filter Panel 
Lamp Door 
3-2
Operated with the keypad, vertical and horizontal offsets shift the lens and move the
image up or down and left or right. Refer to Section 2, Installation and Setup and
Section 6, Specifications for ranges and other details.
Operated with the keypad, closing the internal shutter blocks the lens internally and
turns the image to off (black). Enlarge the diameter of the iris—a.k.a. optical
aperture—for optimized brightness; reduce the diameter to optimize contrast ratio.
Two eyebolts on bottom (factory-installed)—for attaching safety cables when
hoisting inverted projectors.
Four eyebolts for top (separate)—for non-inverted hoisting.
NOTE: Two additional safety eyebolts required.
Handles are for brief hand transport only. Not used for hoisting, rigging, or as safety
points.
NOTE: Optional on Mirage models.
Used for stacking up to three projectors. Refer to Section 2 for details.
Use Christie stacking mounts only.
Turn the four adjustable feet to increase or decrease height and/or tilt as needed. For
most installations the projector will likely be slightly inclined to match the screen tilt
– this reduces the amount of vertical offset required. Refer to 2.3, Projector Position
and Mounting or the Roadster, Matrix WU, Mirage S+/HD/WU User Manual for
more details.
The filter door is a louvered grille for air intake. Remove to access and replace air
filter.
The lamp door is a louvered grille for accessing and replacing the lamp module.
NOTE: Lamp replacement requires a qualified service technician.
Input Panel
The input panel wires the projector to inputs (sources) and controllers such as PCs.

COMPOSITE/S-VIDEO INPUT -
signal from devices such as VCRs.

Accepts RGB and sync signals from devices such as computers, as
RGB INPUT -
well as composite video, S-Video or YPbPr component signals.

RS-232 SERIAL INTERFACE (WITH LOOP THROUGH) -
projectors to be remotely controlled by a computer or controller,

Allows one or more projectors to be remotely controlled by
RS-422 INTERFACE -
an RS-422 compatible computer or controller (such as the Two-Way Controller
accessory).
WARNING
Accepts a composite video, DVI and S-Video
Allows one or more
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)