Ethernet; System Error Code 1F; System Error Code 1E; 3D Sync Input - Christie Roadster User Manual

Troubleshooting
5.3

Ethernet

5.4

3D Sync Input

Symptom
CAUSE / REMEDY:
Symptom
CAUSE / REMEDY:
5-4
1. Ensure the Ethernet settings are valid for your site—all network devices should
have the same subnet mask and unique IP addresses.
2. Ensure the projector is connected to a network before you attempt to change its
IP address, and always cycle power (off-on) to implement the new IP address.
3. Ensure address changes have been saved, and re-boot to implement.
4. If you still have trouble establishing communications with a projector added to an
existing Ethernet network, the projector's IP address is likely in conflict with
another address already in use. Contact your network administrator.


System Error Code 1E...

1. Cable not connected to specify Sync Input.
2. Connect cable.


System Error Code 1F...

1. Sync is present, but out of range.
2. Previous hook up to projector was sending Sync to Emitter. Change 3D Sync
Output to Next.
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)