Maintenance
4-12
Improper installation could cause a serious
7. RE-INSTALL LAMP RETAINING BAR
Position the retaining bar along the bottom edge of the lamp module, with its
ends under the alignment guides. If the bar does not fit, push the lamp module
further in. See Figure 4.6.
The tightening order of the screws is
critical for proper lamp contact and alignment.
Secure screw B until just engaged.
Secure screw A until just engaged.
Go back and forth between A and B to lock the bar in place with even
pressure and correctly position the lamp module.
8. CLOSE LAMP DOOR
Close the lamp door and lock its two (2) ¼-turn lock screws.
IMPORTANT:
The lamp module is calibrated for maximum
performance and brightness in this projector. Do not attempt to re-align
or adjust the lamp module.
9. RECORD THE SERIAL NUMBER OF THE NEW LAMP
Plug in the projector and power it up.
In the Lamp menu, select "Change Lamp".
In the Lamp S/N text box, enter the serial number.
Press to record the number and to reset the lamp timer. The timer will now
begin to log time for the new lamp.
WARNING
meltdown inside the projector.
IMPORTANT
Figure 4.6. Install Retaining Bar
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)