Connect The Line Cord; Turn On The Projector And Lamp; Specifications - Christie Roadster User Manual

Installation & Setup
STEP 4 
STEP 5 
2-2

Connect the Line Cord

The North American-rated line cord is provided with each projector. Ensure
that you are using a line cord, socket and power plug that meets the
appropriate local rating standards.
Connect the projector's line cord to the AC receptacle (Roadster
S+20K/HD18K/Mirage HD18 have non-detachable line cords) at the lower corner on
the rear of the projector, and to proper AC—note the outlet must be near the
equipment and easily accessible. Use only the line cord provided with the projector
or a power cord of appropriate ratings that comply with regional standards. (See
below and refer to Section 6 – Specifications for complete details on all power
requirements).
Line cord replacement must be performed by qualified service
personnel in accordance with specific national electrical safety
regulations. For details, refer to the Service Manual and contact
 The Roadster S+12K/HD12K, Matrix WU12, and the Mirage HD12/WU12
require 200-240 VAC, 50-60 Hz, 12 amps @ 200 VAC.
 The Roadster S+16K and the Mirage S+14K require 200-240 VAC, 50-60 Hz,
16 amps @ 200 VAC.
 The Roadster S+20K/HD18K/Mirage HD18/WU18 require 200-240 VAC, 50-
60 Hz, 24 amps @ 200 VAC.
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range. Refer to Section 6.

Turn On the Projector and Lamp

1. On the projector, turn the power
breaker/switch on. The LCD Status
Display Window displays the
initializing window for 15 seconds,
and then indicates
POWER OFF
(Figure 2.1).
2. Using the keypad, do one of the
following:
• Press and hold briefly to
toggle the lamp on.
• Press and release
immediately by .
• Press to toggle from the
off state.
The LCD Status Display Window
will display Powering Up and
then, Power On (Figure 2.1)
while the two-digit Status/Error
Code Window will display ON.
WARNING
your dealer.
WARNING
followed
Figure 2.1. Turning on the projector
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)