Wired Remote - Christie Roadster User Manual

Operation
Wired Remote 
3-6
The IR remote keypad controls the projector by way of wireless communications
from a battery-powered infrared (IR) transmitter. Use the IR remote keypad the same
way you would use a remote keypad supplied with a TV or VCR. When making key
presses, direct the keypad either toward the screen or toward the front or rear of the
projector. One of the two IR sensors on the projector will detect the signals and relay
the commands for internal processing.
NOTE: For improved reception, use an optional remote IR sensor to route the signal
via a phone cable plugged into the wired keypad port.
You can convert the IR remote into a wired remote keypad using the cable provided
with the projector. Connect one end into the remote and the other to the mini stereo
connector on the input panel labeled as
when:

The built-in keypad is inaccessible

The lighting conditions are unsuitable for proper IR transmission
NOTE: Leave the batteries in the wired remote for the laser key (
The "Brick" style rental staging – Standard IR Remote, typically used with Roadster
models, is shown in Figure 3.4. It has no laser pointer, but includes three additional
keys: the Swap key for use with PIP functions, Backlight key for lighting keys, and
direct Input key used with the numbered keypad to switch from one input to another.
. The wired remote is recommended
REMOTE
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
) to work.
020-100002-05 Rev. 1 (02-2010)