Projector Positioning For Proper Airflow; Lamp And Filter - Christie Roadster User Manual

Lamp and Filter 
Replacement
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
Projectors that are positioned too closely to one another, too close to a wall or other
structures are restricted from the amount of cool air needed to operate without
overheating. Without proper airflow, the hot exhaust air can circulate the projector
and be sucked back in through the intake vents causing it to overheat. See the
illustration below to ensure your projector installation meets the proper spacing
requirements.
Figure 4.1. Projector positioning for proper airflow
Do not operate the Bubble lamp for more than the lamp's warranty limit; risk
LAMP:
of the lamp shattering increases as a result of changes in the quartz glass that occur
with use. Operation beyond the lamp's warranty limit also significantly reduces
brightness output.
Wait approximately five minutes after powering down the
projector to allow internal cooling fans to stop and for the lamp
to cool sufficiently before removing.
Never attempt to remove the lamp housing directly after use.
The lamp is under great pressure when hot and may explode,
causing personal injury and/or property damage. Allow cooling
The Bubble lamp operates at a very high temperature and pressure. Failure to allow
the lamp to sufficiently cool prior to handling could result in an explosion causing
personal injury and/or property damage. After turning the projector off it is important
that you wait at least five minutes before unplugging it. This provides enough time
for the internal lamp cooling fans to cool the lamp and to automatically shut off. Cool
completely before handling.
WARNING
completely.
Maintenance
4-3