Time-Outs; Accessing General Help Topics; The Global Icon; The Pip Icon - Christie Roadster User Manual

Time-outs 
The Global Icon 
The PIP Icon 
Using Slidebars 
And Other Controls
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
Figure 3.7. Accessing General Help Topics
If a slidebar, menu, or message is displayed, you have limited time in which to make
a keypad entry before the projector returns to presentation level
disappears. These time-outs may vary depending on what is displayed.
Menu options that include this icon apply universally to any incoming signal.
Menu options that include this icon apply to PIP (secondary) images only.
Most of the function menus allow you to change settings by using slidebars,
checkboxes, and pull-down lists. To select a slidebar, toggle a checkbox status, or
view a pull-down list, do one of the following within the function menu:

Enter the menu option number corresponding to the setting you wish to change
(for example, press
the Size & Position menu).

Or move the highlight to the option desired and press

Or move the highlight to the option desired and press
immediately.

Or bypass the menus entirely and use a single key to immediately access an
adjustment during your presentation
NOTE: applies only to options having their own key, such as Contrast,
Brightness, Gamma, etc.

For "blind" access, hide the entire menu system (Refer to OSD key, above)
and/or direct slidebars activated by their own key (such as Contrast, Brightness,
etc.). Control by using the proper key press or numerical sequence of key presses.

When using PIP images, use
Once selected, change the settings as desired (see below). Changes take effect
immediately and are saved upon exit from all menus, or after 15 minutes.
Slidebars in menus – The current value for a given
parameter, such as size or vertical stretch, appears to the left of
its slidebar icon (adjustment window). This number often expresses a percentage, or
it may have units associated with it (such as pixels, degrees Kelvin, etc.), depending
on the specific option. Press
both the number and the length of the bar change accordingly. Hold for continuous
adjustment. Or press
the keypad and then press
from the main menu to select Vertical Stretch in
1 3
key to adjust the image.
to gradually adjust the setting up or down—
to activate a slidebar text box for specific number entry via
to save (or press
and the graphic
Help
(Enter).
to adjust
to cancel).
Exit
Operation
3-15