Ethernet Communications; Rs-422 Connection To A Computer; Connecting Ethernet - Christie Roadster User Manual

Ethernet Communications 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
Figure 2.28. RS-422 Connection to a Computer
Do not use an RS-422 port unless you are using
equipment with RS-422 capability. The voltage levels of
this signal can damage incompatible equipment.

Ethernet Communications

To add the projector to an existing Ethernet network with other equipment such as
controllers and other projectors, connect standard CAT5 Ethernet cable between your
Ethernet controller (or hub) and the Ethernet port at the rear of the projector as shown
in Figure 2.29.
CONNECTING TO A PC:
(rather than a network or hub), ensure a crossover Ethernet cable is used.
Upon connection to an Ethernet network, the projector's factory default IP address of
0.0.0.0 will automatically enable the DHCP function (if available on the network) to
assign a new IP address that is valid and unique for that network. Or, if there is no
DHCP function available on the network (or if a specific static IP address for the
projector is preferred or required), you can set the address in the Ethernet Settings
submenu or via an ASCII serial command.
WARNING
If you are connecting the Ethernet port directly to a PC
Figure 2.29. Connecting Ethernet
Installation & Setup
2-23