Filter Replacement; Remove Filter Door; Replace Filter - Christie Roadster User Manual

Filter Replacement

Procedure
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
Lamp Hours
Lamp S/N
1. Lamp Message
2. Lamp Limit
3. Lamp Mode
4.
5. Intensity
6. Optical Aperture
7. Lamp History
8. Change Lamp
If you neglect to enter a serial number, the lamp timer
IMPORTANT:
will not reset to "0" and will therefore be inaccurate. The lamp life limit
may then expire prematurely.

The filter located at the front side of the projector should be replaced whenever the
lamp is replaced. If you are working in an extremely dusty environment you may
want to replace the filter sooner. Use the filter provided in the Christie approved
Lamp and Filter Kit for your specific projector model (see Table 4.2).
1. TURN OFF THE PROJECTOR, COOL and UNPLUG
Before removing or installing a filter, turn off the projector and allow it to cool
for 5 minutes before unplugging.

2. REMOVE FILTER DOOR

Loosen the ¼-turn screw at the top of the
filter grille/door. Lift the door away from
the projector. See Figure 4.7.
NOTE: In the Roadster
S+20K/HD18K/Mirage HD18/WU18, also
remove the triangular metal filter brace.

3. REPLACE FILTER

Remove the old filter and insert the new one. Follow the
airflow arrows for correct orientation. See Figure 4.8. In
the Roadster S+20K/HD18K/Mirage HD18/WU18, which
has a rhomboid-shaped filter, insert the sharply angled
corner first – place fully back on the left. Ensure the
triangular metal filter brace is installed after the filter has
been positioned. See Figure 4.9.
Lamp
0
?
1000
Power
Power
500
0
3
WARNING
Use Christie approved filters ONLY.
Maintenance
New serial# entry
Lamp History
automatically updates
Lamp History...
S/N
Lamp S/N
5679
...and resets Lamp 1234
Hours to "0"
Figure 4.7. Remove Filter Door
Figure 4.8. Airflow
Hours
1001
0
4-13