Introduction; Affected Products; Site Requirements; Power Connection - Christie HS 2K Series Service Manual

Introduction

This document provides technical information for assisting Christie qualified technicians in the servicing
of the Christie HS Series DWU1612-HS,DWU2022-HS projection systems.
Every effort has been made to make sure the information in this document is accurate and
complete. However, due to continuing research all information is subject to change without notice.
Christie assumes no responsibility for omissions or inaccuracies.

Affected products

The following products are affected:
• Christie DWU1612-HS
• Christie DWU2022-HS

Site requirements

To safely install and operate the projector, the installation location must have restricted access for
authorized personnel only and meet these minimum requirements.
Notice. If not avoided, the following may result in equipment or property damage.
• Risk Group 3 products require restricted access.
• Replacement of optical light engine parts must be done in a clean room.

Power connection

The projector uses an AC power system that allows the projector to operate at full brightness with a
power supply of 120-240 VAC or 200-240 VAC, depending on the models and regions. Operating the
device outside of the voltage range may cause unsatisfactory operation or damage to the projector.
Christie recommends a 20 A rated wall breaker for the installation. To ensure safety operation, only
use the AC power cord provided with the product or recommended by Christie.

Projector components

Identify the main components of the projector.
HS Series 2K Service Manual—DWU1612-HS,DWU2022-HS
020-001790-01 Rev. 1 (03-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
7