Servicing; Cleaning; Maintenance Guide - Christie Roadster User Manual

Servicing 
4.2

Cleaning

Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
If any of the following conditions exist, immediately unplug the projector from the
power outlet and contact your Christie dealer.

The power cord has been damaged.

The internal cooling fans do not turn on within two minutes when the projector is
first powered up.

Liquid has been spilled into the projector.

The projector has been exposed to excessive moisture.

The projector is not operating normally or its performance has significantly
deteriorated in a short period of time.

The projector has been dropped or the shipping case (if applicable) has been
badly damaged.
Do not attempt to service the projector yourself. All servicing
must be performed by Christie accredited service technicians.
Use replacement parts that are manufacturer-approved only.
Use of any other part other than the ones specified by the
manufacturer can result in fire, electric shock or risk of personal
injury and irreparable equipment damage.
Table 4.1. Maintenance Guide
Part Description
Lens
WARNING
Frequency
As required CLEAN: Clean the lens only when
absolutely necessary. A small amount of
dust on the lens has very little effect on
picture quality.
To clean: Use a soft lint-free cloth without
any chemicals. Use only a high-quality
coated optics cleaning fluid, which can be
purchased from most camera supply stores.
Apply the coated optics fluid directly onto
the lint-free cloth until moistened. Wipe in a
single sweep across the surface of the lens.
To avoid scratching the lens do not scrub or
rub in a circular motion. Discard the cloth
after every use. Do not use cleaning tools
treated with Ether. Do not use cleaning
solvents that contain ammonia. Use
compressed air to remove any particles
remaining on the lens.
Maintenance
Action
4-5