Stacking Procedure; Position The Projectors; Adjust The Feet - Christie Roadster User Manual

Stacking Procedure 
STEP 1 
STEP 2 
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
• Maximum stack = three projectors.
NOTES: 1) Requires stacking hardware provided standard with Roadsters only.
Available separately for Matrix and Mirage Series. 2) Installation requires at least
two people.
Roadster, Matrix, and Mirage projectors can be stacked in either the upright or
inverted position. Do not mix orientations—i.e., inverted with upright—in a stack.
Secure a maximum of three projectors with the stacking mounts as described below.
Do not stack more than three projectors.
Christie stacking hardware required. The top
projector could slide off and cause injury or death.

Position the projectors

Place the projectors to be
stacked on a secure table or
cart.
 Place one projector on its
side to access its
adjustable feet and
stacking legs (Figure
2.10).
 Orient the other projector
in either upright or
inverted position as
required (remember,
each projector in a stack
must be in the same
orientation).
Fully retract the four
adjustable feet
Retract each foot as far as possible by turning it clockwise.

If upright – retract the feet on top projector.

If inverted – retract the feet on bottom projector.
WARNINGS
• Stack first, then hoist.
WARNING
WARNING
WARNING
Never carry a stack.
Figure 2.10. Adjust the Feet
Installation & Setup
2-7