Copy X/Y Values Into All Projectors - Christie Roadster User Manual

Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
Figure 3.29. Copy X/Y Values into All Projectors
6. In each projector, judge by eye and adjust x/y coordinates slightly in the following
manner:

To match reds, decrease "Red
X" until full field red screens
match.

To match greens, decrease
"Green Y" until full field
green screens match.

To match blues, increase both
"Blue X" and "Blue Y" until
full field blue screens match.
NOTE: For speed, enable the
"Auto Color Enable" checkbox.
Each color coordinate you select will then automatically trigger a full field display
of the corresponding color.
Alternatively, use the Color Saturation menu for these adjustments or to fine tune.
These coordinate adjustments move the three color points closer together (refer
back to the chromaticity chart shown in Figure 3.23) to establish a "shared"
gamut attainable by all projectors in your group. Adjust only as necessary to
ensure that the resulting color palette is as large as possible. When done, you may
need to adjust lamp power slightly.
7. All screens should now be color-matched and the will remain matched upon exit
from the menus. Apply this new "User" gamut to a source at any time by selecting
it in the "Select Color Adjustment" list accessed in the Advanced Image Settings
menu.
Operation
3-67