Default Color Adjustments; Intelligent Lens System; Test Pattern Grey Level - Christie Roadster User Manual

Operation
System Configuration 
DIAGNOSTICS / CALIBRATION
3-54
NOTES: 1) Refer to section 3.11, Using Multiple Projectors for additional
information. 2) There is a centerline (both horizontal and vertical) in the Black Level
Blending test pattern. The intersection of these lines is the true center of the
projector's display area. 3) Adjust white levels before adjusting black levels. 4)
Blinders are recommended for fixed installations.

Default Color Adjustments

Refer to System Configuration – Geometry and Color, Color Adjustments by X, Y
for description.
Intelligent Lens System (ILS
ILS provides the ability to recall focus and zoom settings specific to each source
input. Custom lens settings you've chosen for any source will be quickly and
accurately applied when you select a source that has already been calibrated. Place a
checkmark in the checkbox to enable ILS. If no calibration has previously been
done you may be prompted to do a full calibration. If a motion calibration has been
done, you will be prompted to complete a reference calibration. If both calibrations
have been done, the checkbox will be checked and ILS enabled. If ILS is
enabled, a reference calibration will be done on power up and the lens will return to
the saved position of the source that is active at the time of power up or to the
position the lens was located when it was powered on. Further adjustments to the
zoom, focus and position will be automatically saved for source the selected source.
If you switch to a source with different lens settings and switch back, the lens will
automatically move to your saved settings upon return. Other sources can be used
without using ILS .
NOTES: 1) Refer to System Configuration – Diagnostics/Calibration, ILS
Calibration for further details about calibration. 2) ILS
setting and will be retained between power cycles.
Test Pattern
Choose the desired internal test
pattern to display, or select OFF
to turn off a test pattern.
Alternatively, use the
Test
for cycling through test patterns.
NOTE: There is a center line
(both horizontal and vertical) in
the Edge Blending test pattern.
The intersection of these lines is
the true center of the projector's
display area.

Test Pattern Grey Level

Set the desired level of grey for displaying in the full gray field test pattern.
— SUBMENU

)
— SUBMENU
1.
2.
3.
key
4.
5. Odd Pixel Adjustment
6.
7.
8.
9.
0. Aspect Ratio Overlay
LiteLOC Calibration
Automatic ILS Lens Calibration
Roadster, Matrix WU, Mirage S+/HD/WU User Manual

control is a preference
Diagnostics and Calibration
Test Pattern
Grid
Grey Level
512
Freeze Image
Color Enable
White
Reserved
Peak Detector
Level Detector
Level Value
512
Calibrate LiteLOC
ILS Calibration
Full Calibration
020-100002-05 Rev. 1 (02-2010)