Client - CalAmp Vanguard 3000 VG3000-PXS-F User Manual

DHCP Configuration

DHCP
Selecting "Enable" will configure this device to assign IP addresses to client devices taken from a pool specified
by the values entered in "Start IP Address" and "End IP Address". Selecting "Disable" will turn off the DHCP
server functionality for the Ethernet interface.

Start IP Address
The DHCP server's IP address pool starting value.

End IP Address
The DHCP server's IP address pool ending value.

Lease Time
Sets the duration, in seconds, that the client is allowed to keep the assigned IP address.

3.4.3 CLIENT

The user can configure up to 20 Access Points. The Vanguard Cellular Broadband Router will try to connect to the best
Access Point in the list that is reachable. When the Vanguard unit connects to an Access Point, it starts a DHCP client on
the interface. The Access Point must provide a DHCP server. The DHCP server must provide an IP address, network
mask and gateway to the Vanguard unit. When the Vanguard unit is connected to an Access Point, the default route is
set to point to the gateway address obtained from the DHCP server.
Note: The Access Point must broadcast the SSID in order for the Client to be able to connect to it.
Figure 30: WLAN — Client
Vanguard 3000 Multicarrier Cellular Data Modem & IP Router PN 134732-VG3000 Rev. D| Page 36