3Com Switch 4800G 24-Port Configuration Manual page 96

96 C 9: VLAN C
HAPTER ONFIGURATION
Configuration procedure
1 Configure Device A
# Create VLAN 2, VLAN 6 through VLAN 50, and VLAN 100.
<DeviceA> system-view
[DeviceA] vlan 2
[DeviceA-vlan2] quit
[DeviceA] vlan 100
[DeviceA-vlan100] vlan 6 to 50
Please wait... Done.
# Enter GigabitEthernet 1/0/1 port view.
[DeviceA] interface GigabitEthernet 1/0/1
# Configure GigabitEthernet 1/0/1 as a Trunk port and configure its default VLAN
ID as 100.
[DeviceA-GigabitEthernet1/0/1] port link-type trunk
[DeviceA-GigabitEthernet1/0/1] port trunk pvid vlan 100
# Configure GigabitEthernet 1/0/1 to deny the packets of VLAN 1 (by default, the
packets of VLAN 1 are permitted on all the ports).
[DeviceA-GigabitEthernet1/0/1] undo port trunk permit vlan 1
# Configure packets from VLAN 2, VLAN 6 through VLAN 50, and VLAN 100 to
pass through GigabitEthernet 1/0/1.
[DeviceA-GigabitEthernet1/0/1] port trunk permit vlan 2 6 to 50 100
Please wait... Done.
1 Configure Device B following similar steps as that of Device A.
Verification
Verifying the configuration of Device A is similar to that of Device B. So only
Device A is taken for example here.
# Display the information about GigabitEthernet 1/0/1 of Device A to verify the
above configurations.
<DeviceA> display interface GigabitEthernet 1/0/1
GigabitEthernet1/0/1 current state: UP
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 0011-2233-5577
Description: GigabitEthernet1/0/1 Interface
Loopback is not set
Media type is twisted pair
Port hardware type is
1000Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 9212
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 100
Mdi type: auto
1000_BASE_T