Logging I Nthrough Telnet; Introduction - 3Com Switch 4800G 24-Port Configuration Manual

3

Introduction

Common Configuration
L
OGGING
You can telnet to a remote switch to manage and maintain the switch. To achieve
this, you need to configure both the switch and the Telnet terminal properly.
Table 10 Requirements for Telnet to a switch
Item
Switch
Telnet terminal
n
After you log in to the switch through Telnet, you can issue commands to the
■
switch by way of pasting session text, which cannot exceed 2000 bytes, and
the pasted commands must be in the same view; otherwise, the switch may
not execute the commands correctly.
If the session text exceeds 2000 bytes, you can save it in a configuration file,
■
upload the configuration file to the switch and reboot the switch with this
configuration file. For details, refer to "Configuration File Management" on
page 985.
The way to log in to a switch using Telnet based on IPv6 is the same as that
■
based on IPv4.
Table 11 lists the common Telnet configuration.
I T
N HROUGH
Requirement
Start the Telnet Server
The IP address of the VLAN of the switch is configured and the route
between the switch and the Telnet terminal is available. (Refer to "IP
Addressing Configuration" on page 121 and "IP Routing Overview" on
page 241 for more.)
The authentication mode and other settings are configured. Refer to
Table 11 and Table 12.
Telnet is running.
The IP address of the management VLAN of the switch is available.
T
ELNET