Call - TANDBERG Codec 3000 MXP Reference Manual

Status Information – xhistory / xhistory.xml

Call

Call [1..20] type = NA / Tlph / Vtlph
protocol = NA / ISDN / H320
direction = NA / Incoming
If type = NA
and protocol = NA
and direction = NA
the following will be included:
<Nothing>
If type = Tlph / Vtlph
and protocol = ISDN / H320 /H323 / SIP
and direction = Incoming / Outgoing
the following will be included:
LogTag: 1
RemoteNumber:
EncryptionIn: Off/DES/AES-128
EncryptionOut: Off/DES/AES-128
CallRate:
DisconnectCauseValue*:
DisconnectCause*:
Duration:
UptimeAtEndOfCall:
BillingCode:
Audio**: PacketsReceived, PacketsLost, PacketsDropped, DurationLossLevel1, DurationJitterLevel1, NumberOfLevel1Bursts, DurationLossLevel2, DurationJitterLevel2, NumberOfLevel2Bursts
Video**: PacketsReceived, PacketsLost, PacketsDropped, DurationLossLevel1, DurationJitterLevel1, NumberOfLevel1Bursts, DurationLossLevel2, DurationJitterLevel2, NumberOfLevel2Bursts
* Disconnect Cause Overview
The DisconnectCause indicates the reason why the call was disconnected. See
The DisconnectCauseValue contains additional information to the DisconnectCause. See
** Packet Loss Levels
Level 1: Packet loss > 5% and Jitter > 100ms
Level 2: Packet loss > 10% and Jitter > 200ms
Status information followed by a
D 13887.08
MAY 2008
/ H323 / SIP
/ Outgoing
DisconnectCause
DisconnectCauseValue
*
will not be shown unless Detailed Level has been set to 2 – see
for an overview of the disconnect causes.
for an overview of the disconnect cause values.
213
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
XACLI – Special commands – xpreferences
TANDBERG 3000 MXP & 6000 MXP