Defaultvaluesset - TANDBERG Codec 3000 MXP Reference Manual

Command Information
DefaultValueSet
Command Description

DefaultValuesSet

Command used to reset
configurations to factory
default values.
Required parameters are identified by an (r) appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
Level: <1..3>
Configurations are divided into
three different storage levels.
The level parameter denotes that
configurations on this level and all
levels below (lower value) are to be
reset.
The complete list of Storage Levels
can be found in Configuration
Storage Levels.
(r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters Result parameters
when OK when error
None As above
151
TANDBERG 3000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand defaultvaluesset level:2
*r Result (status=OK):
*r/end
OK
& 6000 MXP