Command Information
CameraTrackingStart — ChairTake
Command
Description
CameraTrackingStart
Command used to turn
camera tracking on.
CameraTrackingStop
Command used to turn
cameratracking off.
CameraUpgrade
Upgrade camera or
video switch with new
software. The software
must be put on a folder
named either /tmp or
/user.
Currently only upgrading
of the first camera
or video switch is
supported.
CameraWhiteBalance
Command used to
initiate calibration of
the whitebalance of the
camera. The command
is valid only when the
Camera Whitebalance
Mode is configured to
Manual.
ChairRelease
Command used to
release chair in a
conference supporting
chair control.
ChairTake
Command used to take
chair in a conference
supporting chair control.
Required parameters are identified by an
(r)
appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
None
None
(r): <1..13> <filename>
Addresses the specific camera or
TANDBERG Video Switch.
Camera software files are named
s01692.pkg.
Video Switch software files are
named s51200.pkg.
Camera(r): <1..13>
Addresses the specific camera.
None
None
(r)
appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters
Result parameters
when OK
when error
None
As above
None
As above
None
As above
None
As above
None
As above
None
As above
146
TANDBERG 3000
MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand cameratrackingstart
*r Result (status=OK):
*r/end
OK
xcommand cameratrackingstop
*r Result (status=OK):
*r/end
OK
xcommand cameraupgrade:1 s01692.pkg
*r Result (status=OK):
*r/end
OK
xcommand camerawhitebalance camera:1
*r Result (status=OK):
*r/end
OK
xcommand chairrelease
*r Result (status=OK):
*r/end
OK
xcommand chairtake
*r Result (status=OK):
*r/end
OK
& 6000
MXP