Telnet; Telnetchallenge; Time - TANDBERG Codec 3000 MXP Reference Manual

Configuration-type Commands – xconfiguration / configuration.xml
SystemUnit

— Time

cont...
SystemUnit DisplayName: <S: 0, 50>
The Display Name part of the SIP Address (URI)
xconfiguration systemunit displayname: MyDisplayNmae
Example:
SystemUnit Password: <S: 0, 16>
Defines the system unit password.
xconfiguration systemunit password: xxx
Example:
T1 Interface

Telnet

Mode: <On/Off>
If set to Off, it will not be possible to connect to the system using Telnet.
Example: xconfiguration telnet mode: on

TelnetChallenge

Mode: <On/Off>
Enables/disables TelnetChallenge.
xconfiguration telnetchallenge mode: on
Example:
TelnetChallenge Port: <23/57>
Specifies whether to port 23 or port 57 for TelnetChallenge.
xconfiguration telnetchallenge port: 57
Example:
Time Zone: <GMT-1200/GMT-1100/GMT-1000/GMT-0930/GMT-0900/GMT-0800/GMT-0700/GMT-0600/GMT-0500/GMT-0400/GMT-0330/GMT-0300/GMT-0200/GMT-0100/GMT/
GMT+0100/GMT+0200/GMT+0300/GMT+0330/GMT+0400/GMT+0430/GMT+0500/GMT+0530/GMT+0545/GMT+0600/GMT+0630/GMT+0700/GMT+0800/GMT+0845/
GMT+0900/GMT+0930/GMT+1000/GMT+1030/GMT+1100/GMT+1130/GMT+1200/GMT+1245/GMT+1300/GMT+1400>
Specifies the time zone where the system is located.
Example: xconfiguration time zone: GMT+0100
Time DateFormat: <DD_MM_YY/MM_DD_YY/YY_MM_DD>
Species the date format to use when presenting dates on the system.
xconfiguration time dateformat: dd_mm_yy
Example:
D 13887.08
MAY 2008
CableLength: <Range1/Range2/Range3/Range4/Range5>
Specifies the length of the cable connected to the T1 interface.
Range1: 0–133 ft (0–40 m)
Range2:
133–266 ft (40–81 m)
Range3: 266–399 ft (81–122 m)
Range4: 399–533 ft (122–162 m)
Range5: 533–655 ft (162–200 m)
xconfiguration t1 interface cablelength: range4
Example:
TelnetChallenge can be enabled on either ip port 23 or ip port 57.
When connecting to an ip port that has telnetChallenge set to On, an MD5
encryption challenge string are being issued instead of a password prompt. An
encrypted password based on the challenge string must then be generated by
an MD5 encryptor and sent back to the system as a response in order to get
access to the system.
Regular Telnet are using ip port 23. When TelnetChallenge is set to ip port
NOTE!
23, this will override regular Telnet.
116
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
MXP