Disconnectcall; Duovideostart; Duovideostop; Dtmfsend - TANDBERG Codec 3000 MXP Reference Manual

Command Information
DisconnectCall — FECCFocus
Command Description

DisconnectCall

Command used to
disconnect a call.

DuoVideoStart

Command used to
initiate DuoVideo/H.239
from the system.

DuoVideoStop

Command used to stop
DuoVideo/H.239.

DTMFSend

Command used to send
DTMF tones to the far
end.
NOTE!
The DTMF tones
are also played back
locally.
NOTE!
This command
is also supported when
the system is not in a
call (the tones will only
be played back locally).

FECCFocus

Command used to
change focus of a far
end camera.
Required parameters are identified by an (r) appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
Call: <1..11>
Reference to the call to be
disconnected. If this parameter is
omitted, all active calls in the system
will be disconnected.
VideoSource: <1..6>
Specifies which video source to be
used for the additional video stream.
If this parameter is omitted, the
system will use the default DuoVideo
source configured for the system,
ref. configuration DuoVideoSource
None
Value(r): <E164: 1, 1>
The DTMF tone to send.
Value(r): <+/->
Specifies whether to increase or
decrease focus.
(r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters Result parameters
when OK when error
None As above
None As above
None As above
None As above
None As above
154
TANDBERG 3000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand disconnectcall call:9
*r Result (status=OK):
*r/end
OK
xcommand duovideostart videosource:5
*r Result (status=OK):
*r/end
OK
xcommand duovideostop
*r Result (status=OK):
*r/end
OK
xcommand dtmfsend value:5
*r Result (status=OK):
*r/end
OK
xcommand feccfocus value:+
*r Result (status=OK):
*r/end
OK
& 6000 MXP