Manage A Gateway Call - TANDBERG MPS User Manual

TANDBERG MPS User Manual
Status
Idle No active call, call just been disconnected.
Establ out Gateway is calling out to destination.
Alerting Call is being connected.
Connected Call is connected.
Clear out Call is being disconnected.
Number ISDN or IP number.
Network
ISDN Call connected is using the H.320 protocol over ISDN.
IP/H. Call connected is using the H.323 protocol over IP.
Duration
Shows the length of the current call.
Encryption (Secure conference
The gateway supports Secure Conference DES and AES.
The single padlock symbol indicates that DES (56 bit) encryption is used.
The double padlock symbol indicates that AES (128 bit) encryption is used.
Indicates that the call is not encrypted.
Note that enabling encryption will reduce the capacity of the Gateway.
Usage
The usage bar shows the current status of all the available resources (CPU, ISDN channels and number of calls)
When the Resource Usage reaches the "Busy on Load"-limit, the gateway will signal this to the gatekeeper. The
gatekeeper will then try to route calls through other gateways. This is done to maintain availability for incoming ISDN
calls when using multiple gateways.
Status
Shows current board status. For details, please see the MCU overview section.

.. Manage a Gateway call

Actions
When a call is active, the Administrator or Operator has the possibility to disconnect the call, or transfer the call from
one IP endpoint to another.
Disconnect Gateway Call
Will disconnect the selected gateway call. A confirmation window will be shown.
Call Transfer (snapshot of Call Transfer dialog needed)
Will open the H.323 Call Transfer window. Here the Administrator or Operator can select an IP entry from the Phone
Book or enter a H.323 Alias/IP address and transfer the H.323 (IP) call to another IP endpoint.
If the transfer fails, the call will be disconnected.

D13373.04
)
TF