Cameratracking; Conference - TANDBERG Codec 3000 MXP Reference Manual

Configuration-type Commands – xconfiguration / configuration.xml
CameraSwUpgrade — Conference
CameraSwUpgrade: <Auto/Off>
If set to Auto the Camera software will be automatically upgraded by the codec. If set to Off, camera software upgrade must be initiated manually by the command CameraForceUpgrade.
NOTE! If codec software is downgraded the camera software must be downgraded manually by the command CameraForceUpgrade. Applies to TANDBERG Precision HD camera only!
xconfiguration cameraswupgrade: Auto
Example:

CameraTracking

Speed: <Slow/Normal/Fast>
Sets the camera tracking speed. Camera tracking is enabled/disabled by the commands
xconfiguration cameratracking speed: normal
Example:

Conference

DefaultCall
Conference DefaultCall
Conference DefaultCall
Conference H323Alias
Conference H323Alias
Conference PeriodicIntra: <0..1000>
Use this setting to generate a new intra frame with a configurable interval. Use this setting with caution since it in a normal network will de-
crease the video quality. The default value is set to 0 which means off. If you configure it to 10 it will send an intra every 10th second.
xconfiguration conference periodicintra: 0
Example:
D 13887.08
MAY 2008
CallRate: <Tlph/1xh221/2xh221/64/128/192/256/320/384/H0/512/768/1152/1472/1920/2560/3072/4096/
Max/Auto>
Defines the default call rate to use when placing calls from the system.
The supported call rates will depend on product type and software options.
NOTE!
Auto: 384 kbps on ISDN/768 kbps on LAN
NOTE!
Example: xconfiguration conference defaultcall callrate: 320
Restrict: <On/Off>
A restricted call uses 56kbps channels rather than the default unrestricted 64kbps channels. Some older networks
(primarily in the USA) do not support 64kbps channels and require the use of restricted 56kbps calls. By default, the
system will dial an unrestricted call and downspeed to 56kbps if necessary.
To force a restricted call, choose Restrict (56k) On.
xconfiguration conference defaultcall restrict: off
Example:
NetProfile: <1..7>
Selects default NetProfile. Please refer to the
xconfiguration conference defaultcall netprofile: 3
Example:
E164: <E164: 0, 30>
Defines the E164 alias for the system. Valid characters are 0-9,
Example: xconfiguration conference h323alias e164: 666666
ID: <S: 0, 49>
Defines the H323Alias ID for the system. If no ID is specified the system will use the SystemUnit Name as
H323Alias ID.
xconfiguration conference h323alias id: MyH323AliasId
Example:
CameraTrackingStart
NetProfile configuration for further details on the supported NetProfiles.
* and #.
73
TANDBERG 3000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
and CameraTrackingStop.
The DefaultCall settings specify
call properties to use if proper-
ties are not specified directly
when placing the call.
The aliases define the telephone
numbers for the unit, i.e. num-
bers to call to reach the unit.
The system can register both an
E164 alias, which can only con-
tain digits (including
an ID, which can also contain
letters.
MXP & 6000 MXP
*
, # ) and