TANDBERG Codec 3000 MXP Reference Manual page 67

Configuration-type Commands – xconfiguration / configuration.xml
Audio
cont...
Audio AutoMute: <On/Off/Unmute>
When automute is set to On, the microphones will be turned off (muted) automatically at boot and at end of calls.
When automute is set to Unmute, the microphones will be turned on (unmuted) automatically at boot and at end of calls.
xconfiguration audio automute: on
Example:
Audio AudioModule: <NAMII-6000/NAMII-7000/NAMII-8000/Digital NAM/None>
Select Audio Module according to the type of Audio Module installed, if this is not automatically detected.
The Audio Module setting will only take effect if the audio module of the system is unidentified.
xconfiguration audio audiomodule: NAMII-6000
Example:
Audio Volume: <0..21>
Sets the volume level output.
Example: xconfiguration audio volume: 10
Audio AGC
Audio AGC
Audio AGC
Audio AGC
Audio EchoControl [1..x]: <On/Off/NoiseReduction>
6000 MXP: x=4
3000 MXP: x=2
Turns echo control On or Off for the various microphone inputs. Microphone 1 is connected to EchoControl 1, Microphone 2 is connected to EchoControl 2 etc.
Line input 1 (Audio input 4 on 6000 MXP) is connected to EchoControl 4 on a 6000 MXP .
xconfiguration audio echocontrol 2: On
Example:
D 13887.08
MAY 2008
Microphones: <On/Off>
Turns the AGC connected to the microphone mixer On or Off. On a 6000 MXP , Line input 1
(denoted Audio input 4 on the rear panel) is also connected to this AGC.
xconfiguration audio agc microphones: on
Example:
AUX: <On/Off>
Turns the AGC connected to the AUX input On or Off.
NOTE! The AUX input is also sometimes referred to as Line Input 2 or AUX / Audio in 5 (6000 MXP) and Line Input 1 or Audio In 3 (3000 MXP).
xconfiguration audio agc aux: on
Example:
VCR: <On/Off>
Turns the AGC connected to the VCR input On or Off.
On the 6000MXP, the VCR input is also sometimes referred to as Line Input 3 or Audio in 6, while on the 3000MXP the VCR input is referred to as
NOTE!
Line Input 2 or Audio In 4. When Stereo I/O is set to On, the VCR input will be Line input 1 & 2 or Audio 5 & 6 (6000 MXP), and Line input 1 & 2 or Audio
3 & 4 (3000 MXP)
Example: xconfiguration audio agc vcr: off
Received: <On/Off>
Turns AGC for received audio On or Off.
xconfiguration audio agc received: on
Example:
67
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
MXP