Mainvideosource; Maxbandwidth; Mcu; Nat - TANDBERG Codec 3000 MXP Reference Manual

Configuration-type Commands – xconfiguration / configuration.xml
LoS

— NetProfile

cont...
LoS Initial: <0..65534>
Specifies the maximum number of seconds to wait for H.221 frame alignment during call setup before asserting the LOS signal.
xconfiguration los initial: 5
Example:
LoS Polarity: <Positive/Negative>
Set LOS pulse polarity.
xconfiguration los polarity: positive
Example:
LoS Retry: <0..65534>
Specifies the number of seconds to wait before issuing a new LOS pulse in case the codec does not regain H.221 frame alignment.
Example: xconfiguration los retry: 25
MainVideoSource: <1/2/3/4/5/6>
Defines which video input to be used as the main video source.
xconfiguration mainvideosource: 2
Example:
MaxBandwidth: <128..10240>
Limit max bandwidth usage for the system. Related to IPMedia MaxVideoTXRate, which only controls upstream bandwidth.
xconfiguration maxbandwidth: 10240
Example:

MCU

MultiSite: <On/Off>
Specify if the optional feature MultiSite should be enabled/disabled.
Example: xconfiguration multisite: on
MCU MultiWay: <On/Off>
Specify if the optional feature MultiWay should be enabled/disabled.
xconfiguration multiway: on
Example:

NAT

Mode: <On/Off/Auto>
When set to On the system will signal the configured "NAT Address" in place of its own IP-address within Q.931 and H.245. When set to
Off the system will signal the real IP Address. When set to Auto the system will try to determine if the "NAT Address" or the real IP-address
should be used within signalling. This is done to make it possible to place calls to endpoints on the LAN as well as endpoints on the WAN.
xconfiguration nat mode: on
Example:
NAT Address: <IPAddr>
This must be the external/global IP-address to the router with NAT support. Packets sent to the router will then be routed to the system. In
the router, the following ports must be routed to the system's IP-address: Port 1720, Port 5555-5574, Port 2326-2373.
Example: xconfiguration nat address: 127.0.0.1
NetProfile [1..7] Name: <S: 0, 8>
Defines the name of the NetProfile.
xconfiguration netprofile 4 name: MyProfile
Example:
D 13887.08
MAY 2008
101
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
LoS configurations are relevant
for systems with NET interface
(External Network) only.
Configuration of NAT (Network
Address Translation) router.
MXP