Boot; Callaccept; Callmute; Callmuteoutgoing - TANDBERG Codec 3000 MXP Reference Manual

Command Information
Boot — CallMuteOutgoing
Command Description

Boot

Command used to
reboot the system.

CallAccept

Command used to
answer an incoming
call if autoanswer is
disabled.

CallMute

Command used to mute
incoming audio from a
specific call in a Multi-
Site conference.

CallMuteOutgoing

Command used to
mute outgoing audio
to a specific call in a
MultiSite conference.
Typical user scenario
for this command is a
three-part conference
where two of the
participants are from
the same company
discussing an issue with
a sub-contractor.
During the conference
the participants from
the same company want
to share some thoughts
in private before making
the final decision.
Required parameters are identified by an (r) appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
ParameterRestore: <On/Off>
When rebooting the system after
software upgrade, all configurations
will be restored.
By setting ParameterRestore to Off,
the system configurations prior to
software upgrade will be lost.
None
Call(r): <1..11>
Reference to the call to be muted or
unmuted.
Mode(r): <On/Off>
Denotes whether the call is to be
muted or unmuted.
Call(r): <1..11>
Reference to the call to be muted or
unmuted.
Mode(r): <On/Off>
Denotes whether the call is to be
muted or unmuted.
(r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters Result parameters
when OK when error
None As above.
None As above
None As above
None As above
143
TANDBERG 3000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand boot parameterrestore: on
*r Result (status=OK):
*r/end
OK
xcommand callaccept
*r Result (status=OK): /
*r/end
OK
xcommand callmute call:2 mode:on
*r Result (status=OK):
*r/end
OK
xcommand callmuteoutgoing call:2 mode:on
*r Result (status=OK):
*r/end
OK
& 6000 MXP