TANDBERG Codec 3000 MXP Reference Manual page 178

Status Information – xstatus /xstatus.xml
Call
cont...
Active
If status = the following will be included:
Protocol: G711 / G722 / G722.1 / G728 / AAC-LD
Rate:
RemoteIPAddress*:
LocalIPAddress*:
Encryption* On / Off)
(status =
Off
If status = the following will be included:
<Nothing>
If status = On the following will be included:
Type: DES / AES-128
RSVP*: On / Off
DynamicRate*:
TotalPackets*:
PacketLoss*:
Jitter*:
PacketsDropped*:
Video [1..2] Active / Inactive):
(status =
Inactive
If status = the following will be included:
<Nothing>
If status = Active the following will be included:
Protocol: H261 / H263 /H263+ / H264
Resolution: QCIF / SQCIF / CIF / 2CIF / 4CIF / ICIF / SIF / 4SIF /ISIF /VGA / SVGA / XGA / QVGA / 448p / 400p / w288p / w448p / w576p / w720p
Rate:
RemoteIPAddress*:
LocalIPAddress*:
Encryption* On / Off)
(status =
If status = Off the following will be included:
<Nothing>
Status information followed by a
D 13887.08
MAY 2008
*
will not be shown unless Detailed Level has been set to 2 – see
178
Appears for incoming calls only
XACLI – Special commands – xpreferences
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
MXP