Unpacking The Video Switch; The Tandberg Video Switch Set Contains; Cameras - TANDBERG Codec 3000 MXP Reference Manual

TANDBERG Video Switch

Unpacking the Video Switch

The TANDBERG Video Switch set contains:

1 Video Switch Unit
4 Rubber Feet
1 HD Camera cable (1 m) for 6000MXP Codec
1 HD Camera cable (1 m) for 3000MXP Codec
1 Power supply kit incl. cables for Video Switch
1 Power supply kit incl. cables for existing camera
1 Rack ear set (left and right)
1 Control cable (6.5 m) for Video Switch to Precision HD camera
1 HDMI cable (6.5 m) for Video Switch to precision HD camera
1 TRC4 TANDBERG Remote Control
Please report any discrepancies immediately.
1
Unpack the unit.
D 13887.08
MAY 2008
2
Mount the rack ears
and/or rubber feet
and mount it in the
rack, if applicable.
233

Cameras

You may combine TANDBERG HD Precision cameras with analog sources equipped with
component video outputs. Just add them to the chain of cameras in the diagram shown overleaf,
but make sure the added sources appear after the TANDBERG HD Precision cameras in the chain
(i.e. after camera 4 in the diagram overleaf).
Consequently, up to four TANDBERG HD Precision cameras may be combined with up to two
analog component video sources and up to three TANDBERG WAVE II cameras, bringing the
maximum number of video sources (which in many cases will be all cameras) up to nine!
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Put the Video Switch power
supply here when rack
mounting.
Rubber feet
(rubber pads)
MXP