Virtualmonitorreset; Virtualmonitorset - TANDBERG Codec 3000 MXP Reference Manual

Command Information
VirtualMonitorReset — VirtualMonitorSet
Command Description

VirtualMonitorReset

Command used to
reset a VirtualMonitor.
By resetting a
VirtualMonitor the
system itself retakes
control over what to
be displayed on the
VirtualMonitor.

VirtualMonitorSet

Command used to
instruct the system
to display a specific
picture on a specific
VirtualMonitor. A
VirtualMonitor can
be displayed on one
or more of the local
video outputs (which
VirtualMonitor a specific
video output is to
display is configurable).
When this command
is issued for a specific
VirtualMonitor the
picture displayed on this
monitor will not change
until the VirtualMonitor
is reset or set to display
another picture.
Required parameters are identified by an (r) appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
VirtualMonitor(r): <1..4>
Addresses which VirtualMonitor to
apply the command.
VirtualMonitor(r): <1..4>
Addresses the VirtualMonitor to
which the command is to be applied.
Picture(r): <LocalMain/LocalDuo/
Still/RemoteMain/RemoteDuo/
JPEG/TandbergMonitor1/
TandbergMonitor2/
PictureProgram1/PictureProgram2/
PictureProgram3/
PictureProgram4/None>
Specifies which of the supported
pictures to display on the addressed
VirtualMonitor.
Call: <1..11>
If RemoteMain or RemoteDuo is
selected, this parameter must be
supplied to select the correct remote
call.
(r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters Result parameters
when OK when error
None As above
None As above
164
TANDBERG 3000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand virtualmonitorreset virtual-
monitor:2
*r Result (status=OK):
*r/end
OK
xcommand virtualmonitorset virtualmoni-
tor:2 picture:still
*r Result (status=OK):
*r/end
OK
& 6000 MXP