Remoteswupgrade; Rtp; Screensaver - TANDBERG Codec 3000 MXP Reference Manual

Configuration-type Commands – xconfiguration / configuration.xml
RemoteSwUpgrade — SerialPort

RemoteSwUpgrade

Mode: <On/Off>
If set to On, software can be upgraded from a far end system.
xconfiguration remoteswupgrade mode: on
Example:
RemoteSwUpgrade Password: <S: 0, 16>
If RemoteSwUpgrade Mode is set to On and a Password is defined, the remote system must supply this Password in order to upload new software to the unit.
xconfiguration remoteswupgrade password: 123
Example:

RTP

Ports: <Static/Dynamic>
Affects the the port numbers used for H.323 call signalling. Dynamic will give random ports. Static will give ports within a static predefined range [5555–5574]. Dynamic should
be used during firewall traversal.
Example: xconfiguration rtp ports: dynamic
RTP MTU: <1200..1400>
Maximum Transfer Unit is the number of bytes of video payload per packet.
xconfiguration rtp mtu: 1200
Example:

Screensaver

Mode: <On/Off>
Enables/disables if screensaver is to be activated if there is no system activity.
xconfiguration screensaver mode: on
Example:
Screensaver Delay: <1..480>
Specifies how long (in minutes) the system shall wait before activating screensaver when there is now system activity.
Example: xconfiguration screensaver delay: 15
SelfViewOnStartup: <On/Off>
If set to On the system will display the local main video source on the main monitor when the system is started.
xconfiguration selfviewonstartup: on
Example:
SerialPort [1] Mode: <Control/Transparent/Direct>
Control: Gives access to the Command Line Interface.
Transparent: Enables transmission of text during call on a line by line basis.
Direct: Enables transmission on binary data during call.
xconfiguration serialport 1 mode: control
Example:
SerialPort [2] Mode: <VISCA/Auto>
Defines Camera control mode.
Example: xconfiguration serialport 2 mode: auto
D 13887.08
MAY 2008
NOTE! Port 1 Only
NOTE! Port 2 Only
110
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
MXP