Floortosite; Floortositeend; Groupentryadd; Groupentrydelete - TANDBERG Codec 3000 MXP Reference Manual

Command Information
FloorToSite — KeyDown
Command Description

FloorToSite

Command used to
assign floor to a specific
site in a MultiSite
conference supporting
H.243.

FloorToSiteEnd

Command used to end
the assignment of floor
to a specific site in a
MultiSite conference
supporting H.243.
Requires that the
command FloorToSite
has been issued in
advance

GroupEntryAdd

Command used to add
a new Group entry to
the locally stored Group
Directory (or MultiSite
Directory). The entry is
stored in the first vacant
position in the Group
Directory.

GroupEntryDelete

Command used to
delete an entry in the
locally stored Group
Directory.

KeyDown

Command used to
emulate pressing a key
on the TANDBERG MXP
remote control without
releasing it. The KeyDown
command should be
followed by a KeyRelease
command to emulate
releasing the key.
Required parameters are identified by an (r) appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
MCuID(r): <1..191>
MCUID to the MultiSite the site is
connected to.
TerminalID(r): <1..191>
The site's terimnal id, referenced to
the MultiSite it is connected to.
None
Name: <S: 0, 48>
The entry's name.
LocalEntryId.1..10: <1..200>
References to local entry ids to be
included in this Group entry.
GroupEntryId(r): <1..50>
Reference to the entry to delete.
Key(r): <0/1/2/3/4/5/6/7/8/
9/*/#/Connect/Disconnect/
up/Down/Right/Left/Selfview/
Layout/Phonebook/Cancel/
MicOff/Presentation/Volumeup/
VolumeDown/OK/ZoomIn/
ZoomOut/Grab>
(r) appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters Result parameters
when OK when error
None As above
None As above
GroupEntryId: As above
<1..50>
Reference to the
Group Directory
position the entry
is stored.
None As above
None As above
157
TANDBERG 3000 MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand floortosite mcuid:85 terminal-
id:2
*r Result (status=OK):
*r/end
OK
xcommand floortositeend
*r Result (status=OK):
*r/end
OK
xcommand groupentryadd name:"My Group
Entry" localentryid.1:1 localentryid.2:7
localentryid.3:9
*r Result (status=OK):
GroupEntryId: 17
*r/end
OK
xcommand groupentrydelete groupentryid:30
*r Result (status=OK):
*r/end
OK
xcommand keydown key: phonebook
*r Result (status=OK):
*r/end
OK
& 6000 MXP