Command Information
SPIDAutoConfigure — TextDisplay
Command
Description
SPIDAutoConfigure
Command used to
initiate automatic
configuration of SPIDs.
StillImageSend
Command used to send
a still image.
StreamingStart
Command used to start
streaming from the
system.
StreamingStop
Command used to stop
streaming from the
system.
TextDelete
Command used to
delete a text line added
by the TextDisplay
command.
TextDisplay
Command used add a
text line on screen.
Required parameters are identified by an
(r)
appended to the parameter name. The
D 13887.08
MAY 2008
Parameters
None
VideoSource: <1..6>
Specifies from which video source to
send a still image. If this parameter
is omitted, the system will use the
default still image source configured
for the system.
None
None
Layer(r): <1..3>
The layer to delete.
Layer(r): <1..3>
Defines the lines position.
Text: <S: 0, 38>
The text to display.
TimeOut: <0..999>
Sets the timeout value for the text
line.
(r)
appears in this table for your information only and shall not be included when writing the commands – see the column Example for an illustration of this. Empty lines in the examples provided may have been removed to save space in the tables.
Result parameters
Result parameters
when OK
when error
None
As above
None
As above
None
As above
None
As above
None
As above
None
As above
163
TANDBERG 3000
MXP
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Example
xcommand spidautoconfigure
*r Result (status=OK):
*r/end
OK
xcommand stillimagesend videosource:5
*r Result (status=OK):
*r/end
OK
xcommand streamingstart
*r Result (status=OK):
*r/end
OK
xcommand streamingstop
*r Result (status=OK):
*r/end
OK
xcommand textdelete layer:1
*r Result (status=OK):
*r/end
OK
xcommand textdisplay layer:1 text:TAND-
BERG timeout:100
*r Result (status=OK):
*r/end
OK
& 6000
MXP