Localentry - Groupentry; Localentry [1; Groupentry [1 - TANDBERG Codec 3000 MXP Reference Manual

Configuration-type Commands – xdirectory / directory.xml
LocalEntry — GroupEntry

LocalEntry [1..200]

Name: <S: 0, 48>
The local entry's name.
xdirectory localentry 26 name: john doe
Example:
LocalEntry [1..200] Number: <S: 0, 60>
The local entry's number.
Example: xdirectory localentry 26 number: 5566
LocalEntry [1..200] SecondNumber: <S: 0, 60>
2Xh221 second number.
Example: xdirectory localentry 26 secondnumber: 5566
LocalEntry [1..200] SubAddress: <S: 0, 20>
xdirectory localentry 26 subaddress: 5436
Example:
LocalEntry [1..200] CallRate: <Tlph/1xh221/2xh221/64/128/192/256/320/384/512/768/1152/1472/1920/2560/3072/4096/Max/Auto>
Specifies the callrate to use when calling this entry.
xdirectory localentry 26 callrate: 64
Example:
LocalEntry [1..200] Restrict: <On/Off>
Specifies wether or not to use Restrict when calling this entry.
A restricted call uses 56kbps channels rather than the default unrestricted 64kbps channels. Some older networks (primarily in the USA)
do not support 64kbps channels and require the use of restricted 56kbps calls. By default the system will dial an unrestricted call and
downspeed to 56kbps if necessary.
xdirectory localentry 26 restrict: on
Example:
LocalEntry [1..200] NetProfile: <1..7>
Defines the NetProfile to use when calling this entry. A NetProfile defines network type and a possible prefix, ref. configuration Netprofile.
Example: xdirectory localentry 26 netprofile: 5

GroupEntry [1..50]

Name: <S: 0, 48>
The Group entry's name.
xdirectory groupentry 22 number: 5566
Example:
GroupEntry [1..50] LocalEntryId [1..10]: <0..200>
References to the local entries to be included in the group entry.
directory groupentry 45 localentryid 7 number: 167
Example:
D 13887.08
MAY 2008
122
TANDBERG 3000 MXP & 6000
REFERENCE GUIDE FOR SYSTEM INTEGRATORS
Defines entries stored locally on
the codec.
NOTE! To add new entries and
remove existing entries, the
LocalEntryAdd
commands /
LocalEntryDelete
should be
used.
Defines group entries (MultiSite
entries) stored locally on the
codec.
NOTE! To add new entries and
remove existing entries, the
GroupEntryAdd
commands
GroupEntryDelete
should be
used.
MXP
/