Copier Management
Entering an ECM Password
An ECM password is required only when the Electronic Copy Monitor (ECM) feature is
activated, a User Password is assigned, and "Enter E.C.M. password" is displayed on the
touch screen.
1 Enter your 8-digit ECM password, using the keypad.
If the ECM password is invalid, the copier will reset to the Initial mode.
In that case, enter the correct password or contact the Key Operator.
2 Press [ Start ] once to display your current copy count and copy limit for 3 sec.
When your copy count reaches the copy limit, the following message is displayed:
In that case, contact the Key Operator to reset your copy limit.
3 Make copying selections, and enter print quantity, as required.
4 When all settings are acceptable, press [ Start ].
NOTE: To restore the initial state, press [C] while pressing [Utility] when the copy cycle is completed. The
message "Enter E.C.M. password" is displayed on the screen.
5-4
Current count / limit
018888/025000
Ready to copy
Copy limit reached
025001/025000