Copier Initial Setting [2] - Konica Minolta Di5510 User Manual

Key Operator Mode

Copier Initial Setting [2]

Initial settings are the settings that display automatically when the copier is powered on,
when Panel Reset timer is operated, or when [Panel Reset] key is pressed. These settings
can be changed by the Key Operator, as shown in this section.
Initially, i.e., at installation, the Basic Screen displays the following condition to meet
Energy Star requirements:
Initial Setting
Copy Mode:
Copy Density: AES
Lens Mode:
Copy Size:
Output Mode:
When Initial settings are changed by the Key Operator, the new initial settings display
when the copier is powered on, when Panel Reset timer is reached, or when [Panel Reset]
key is pressed.
The following initial settings can be changed by the Key Operator:
Copy Mode:
Copy Density: [AES; manual]
Lens Mode:
Copy Size:
Output Mode: [Non-sort; Sort; Group; Staple-sort; Stapling & Folding; Folding;
Special Original: [Original Direction; Duplex Binding; Text/Photo Enhance; Special
Rotation:
Setting procedures are described on the following pages.
NOTE: The most commonly-used settings are established at installation. Before changing any of the copier
settings, be sure that you understand the overall and long-range effect of the change.
1-1
1:1
APS
offset sort
[EDH; 1-1; 1-2; 2-2; 2-1]
[AMS; ratio 0.250~4.000]
[APS; trays 1, 2, 3, 4 or LCC]
Punch; Three-folding; cover sheet]
Original; Original
Form]
OFF
13-11