Konica Minolta Di5510 User Manual page 381

Troubleshooting
Copying Hints (continued)
COPYING DOES NOT BEGIN AFTER PRESSING START
Insert or adjust the appropriate paper tray for copy size selected.
Close document cover firmly.
Close Front doors and Toner access door of main body completely.
Close Finisher door completely.
COPYING DOES NOT RESUME AFTER MISHANDLED PAPER IS REMOVED
Check copier diagram on touch screen for additional indications of mishandled paper.
THE ORIGINAL PAPER IS MISHANDLED OR SKEWED IN THE EDH
Originals should conform to the recommended size and weight.
Be sure originals are not stapled.
Align originals evenly in the EDH.
Check to make sure paper guides meet the width of mixed size originals.
COPY IMAGE IS SKEWED WHEN BYPASS IS USED
Be sure copy paper is inserted straight.
USING ECM, COPIES CANNOT BE MADE AFTER PASSWORD IS ENTERED
Check to see if the message EXCEEDS LIMIT is displayed.
Contact Key Operator to reset limit.
FINISHER DOES NOT OPERATE
Press OUTPUT APPLI. key.
Check for a paper misfeed and remove it, as required. Properly close finisher door.
EDH INDICATOR WILL NOT LIGHT AFTER AUTO/RESET IS PRESSED
Fully close EDH.
EDH LIGHT IS FLASHING
The EDH is ready to accept originals.
Insert originals on EDH tray, press [Panel Reset], then [Start].
ADD TONER MESSAGE IS DISPLAYED
New toner supply is needed. Follow instructions for adding toner.
CALL FOR PM IS DISPLAYED IN MESSAGE AREA
Contact your service representative for Preventive Maintenance.
APS SELECTS THE WRONG PAPER SIZE
Paper guides must be adjusted exactly to the size of originals.
15-9